Sand concrete garage slab to prep for epoxy coating and remove lai...

Before you start sanding a concrete garage slab, set two things: the goal (prep for epoxy coating and remove laitance) and the inspection method (angled light). This workflow uses 400–1500 grit in a steady progression so you don’t chase scratches at the end.

One grit at a time, no skipping.

Why Sanding Matters

Sanding removes defects and creates the surface profile for the next stage. Deep scratches left behind can show through after paint, clear coat, or polishing. A controlled progression makes finishing predictable.

Recommended Tools

• Sandpaper sheets
• Sanding block/pad
• Microfiber cloths
• Vacuum/brush
• Masking tape
• Bright light for inspection

Recommended Grit Sequence

Use the sequence below in order. Inspect between steps and only move up when older scratches are removed.

• 400 grit: prep, then inspect before moving up.
• 600 grit: prep, then inspect before moving up.
• 800 grit: prep, then inspect before moving up.
• 1000 grit: prep, then inspect before moving up.
• 1500 grit: prep, then inspect before moving up.

Step-by-Step

1. Protect adjacent areas. Tape trim, edges, and nearby surfaces you don’t want to scuff.
2. Clean first. Remove oils and dust so the paper cuts evenly.
3. Start with 400 grit. Use even strokes and a block where possible to avoid waves.
4. Wipe and inspect. Confirm one consistent scratch pattern before moving up.
5. Step up through 600 and 800 grit. Slightly change direction between grits and reduce pressure.
6. Refine with 1000 grit. Keep motion steady; avoid sanding in one spot.
7. Finish with 1500 grit. This sets your final surface profile for prep for epoxy coating and remove laitance.
8. Final cleanup. Vacuum/brush, then wipe with a clean cloth before the next stage.

Special Cases

If a deep scratch appears late, drop back one grit step and remove it before continuing.

Pro Tips

• Swap sheets when they stop cutting; clogged paper can leave random scratches.
• Reduce pressure as grits get finer.
• Wipe between grits so inspection is accurate.
• Use a block on flats to avoid finger grooves.
• Set your endpoint before sanding. Knowing the goal prevents over-sanding the later steps.

Aftercare

• Remove dust from seams and corners before coating.
• If wet sanded, dry fully before primer/paint/clear coat.
• Store unused sheets flat and dry.
• Discard heavily loaded sheets so old finish doesn’t re-scratch the surface.

FAQs

• Can I skip a grit? Skipping often leaves deeper scratches that show later. Use the sequence for predictable results.
• How do I know when to move up? When the scratch pattern is uniform and you can’t find lines from the previous grit under angled light.
• Why does the finish still look uneven? Usually because the first grit step wasn’t completed or debris re-scratched the surface.

Watch & Learn

Here are the exact grits referenced in this workflow so you can match the sequence: 60 grit (pack of 50), 1200 grit (pack of 50), 1000 grit (pack of 50).

• 60 Grit Sandpaper Sheets — Pack of 50
• 1200 Grit Sandpaper Sheets — Pack of 50
• 1000 Grit Sandpaper Sheets — Pack of 50

Complete each grit step, inspect under angled light, and keep pressure light at the end. That’s the simplest route to a finish-ready surface.