Sanding brass lamp base: remove tarnish and prep for a bright polish

Sanding is scratch replacement: each grit removes the previous scratch pattern and replaces it with a finer one. This workflow sands a brass lamp base to remove tarnish and prep for a bright polish through 120–600 grit by completing each step before moving up.

One scratch size at a time.

Why Sanding Matters

Sanding removes defects and creates the surface profile for the next stage. Deep scratches left behind can show through after paint, clear coat, or polishing. A controlled progression makes finishing predictable.

Recommended Tools

• Sandpaper sheets (fresh sheets ready)
• Sanding block/pad
• Bright light for inspection
• Microfiber cloths
• Vacuum/brush
• Masking tape
• Isopropyl alcohol / degreaser for final wipe

Recommended Grit Sequence

Use the sequence below in order. Inspect between steps and only move up when older scratches are removed.

• 120 grit: replace the previous scratch pattern completely before moving up.
• 220 grit: replace the previous scratch pattern completely before moving up.
• 320 grit: replace the previous scratch pattern completely before moving up.
• 400 grit: replace the previous scratch pattern completely before moving up.
• 600 grit: replace the previous scratch pattern completely before moving up.

Step-by-Step

1. Protect adjacent areas. Tape trim, edges, and nearby surfaces you don’t want to scuff.
2. Clean first. Remove oils and dust so the paper cuts evenly.
3. Start with 120 grit. Use even strokes and a block where possible to avoid waves.
4. Wipe and inspect. Confirm one consistent scratch pattern before moving up.
5. Step up through 220 and 320 grit. Slightly change direction between grits and reduce pressure.
6. Refine with 400 grit. Keep motion steady; avoid sanding in one spot.
7. Finish with 600 grit. This sets your final surface profile for remove tarnish and prep for a bright polish.
8. Final cleanup. Vacuum/brush, then wipe with a clean cloth before the next stage.

Special Cases

If a deep scratch appears late, drop back one grit step and remove it before continuing.

Pro Tips

• Swap sheets when they stop cutting; clogged paper can leave random scratches.
• Reduce pressure as grits get finer.
• Wipe between grits so inspection is accurate.
• Use a block on flats to avoid finger grooves.
• If scratches persist at a fine grit, go back one step and remove them before continuing.

Aftercare

• Remove dust from seams and corners before coating.
• If wet sanded, dry fully before primer/paint/clear coat.
• Store unused sheets flat and dry.
• Discard heavily loaded sheets so old finish doesn’t re-scratch the surface.

FAQs

• Can I skip a grit? Skipping often leaves deeper scratches that show later. Use the sequence for predictable results.
• How do I know when to move up? When the scratch pattern is uniform and you can’t find lines from the previous grit under angled light.
• Why do random deep lines appear? Often from debris or loose grit. Wipe/vacuum more often and swap sheets sooner.

Watch & Learn

Here are the exact grits referenced in this workflow so you can match the sequence: 360 grit (pack of 100), 240 grit (pack of 100), 280 grit (pack of 100).

• 360 Grit Sandpaper Sheets — Pack of 100
• 240 Grit Sandpaper Sheets — Pack of 100
• 280 Grit Sandpaper Sheets — Pack of 100

Complete each grit step, inspect under angled light, and keep pressure light at the end. That’s the simplest route to a finish-ready surface.