How to Sand Granite Countertop Edge to remove haze

Granite Countertop Edge sanding works best when you move up in measured steps. Use the progression below to remove haze while keeping scratches predictable and easy to refine.

Why Sanding Matters

A consistent grit progression removes the previous grit’s scratches step-by-step. This is the most reliable way to reduce haze, avoid random deep gouges, and get a uniform surface that polishes or paints more predictably.

Tools

• Sanding block (flat areas) + flexible backing (curves)
• Spray bottle with water (helpful on finer grits)
• Microfiber cloths
• Masking tape (protect trim/edges)
• Raking light (flashlight held low to reveal scratches)

Recommended Grit Sequence

• 400 grit – Defect removal / first cut
• 600 grit – Remove the first grit’s scratches
• 800 grit – Refine for smoother finish
• 1200 grit – Final refinement before polish/seal/paint

Step-by-Step

1. Clean and tape off adjacent areas. Remove dirt and protect trim/paint edges so you only sand where intended.
2. Start with your first grit using light, even pressure. Use 400 Grit (25 Pack). Work until the defect pattern is replaced by a uniform scratch pattern.
3. Control loading and heat. If the sheet clogs, switch to a fresh piece. On finer grits, a light mist of water can help keep scratches consistent.
4. Move up and erase the previous scratches. Use 600 Grit (25 Pack) with lighter pressure. Don’t advance until deeper lines are gone under raking light.
5. Finish with the final grit for your goal. Use 800 Grit (25 Pack) to refine the surface so polishing, sealing, or paint prep goes faster.
6. Final wipe-down. Clean off residue completely so you can judge the finish without haze.

Special Cases

Heat control: Use light pressure and keep the surface controlled (especially on plastics). Heat can smear material and create new haze that looks like scratches.

Paint prep plastics: Don’t over-polish before paint—your final grit should leave consistent tooth for adhesion.

Pro Tips

• Use raking light often. It shows remaining scratches immediately.
• Replace sheets early. Loaded paper causes random deep scratches.
• Don’t skip steps. Each grit removes the last grit’s scratches faster than trying to fight them with a much finer grit.
• Keep strokes consistent. Long overlapping passes blend better than short scrubbing.

Aftercare

• Wash/wipe residue away so the surface stays clean.
• Let the surface dry fully before polishing, painting, or sealing.
• If restoring clarity, follow sanding with polishing and protection.
• Store sheets flat and dry to prevent curling.

FAQs

• Wet or dry sanding? Dry works for many prep steps. Wet sanding on finer grits often reduces loading and improves scratch consistency.
• Why do I still see haze? Usually leftover scratches from a lower grit. Go back one step, remove them fully, then continue.
• Can I jump to a very fine grit? It usually takes longer and gives less consistent results than a steady progression.
• How do I avoid deep random scratches? Keep pressure light and replace sheets when they start loading.

Watch & Learn

To repeat the same controlled progression you just watched, keep these grits ready and move up step-by-step: 400 Grit (25 Pack), 600 Grit (25 Pack), 800 Grit (25 Pack).

Once the scratch pattern is uniform under good light, polishing or finishing becomes much more predictable. The biggest time-saver is simply not skipping grit steps.