Sand resin 3D printed figurine to smooth support marks without los...

Think “scratch texture,” not just “smooth.” Your job at each grit is one consistent scratch texture, then you replace it with a finer texture at the next grit. This workflow sands a resin 3D printed figurine to smooth support marks without losing detail through 320–1000 grit using that approach.

One texture at a time.

Why Sanding Matters

Sanding removes defects and creates the surface profile for the next stage. Deep scratches left behind can show through after paint, clear coat, or polishing. A controlled progression makes finishing predictable.

Recommended Tools

• Sandpaper sheets (fresh sheets ready)
• Sanding block/pad
• Bright light for inspection
• Microfiber cloths
• Vacuum/brush
• Masking tape

Recommended Grit Sequence

Use the sequence below in order. Inspect between steps and only move up when older scratches are removed.

• 320 grit: aim for one consistent scratch texture per step.
• 400 grit: aim for one consistent scratch texture per step.
• 600 grit: aim for one consistent scratch texture per step.
• 800 grit: aim for one consistent scratch texture per step.
• 1000 grit: aim for one consistent scratch texture per step.

Step-by-Step

1. Protect adjacent areas. Tape trim, edges, and nearby surfaces you don’t want to scuff.
2. Clean first. Remove oils and dust so the paper cuts evenly.
3. Start with 320 grit. Use even strokes and a block where possible to avoid waves.
4. Wipe and inspect. Confirm one consistent scratch pattern before moving up.
5. Step up through 400 and 600 grit. Slightly change direction between grits and reduce pressure.
6. Refine with 800 grit. Keep motion steady; avoid sanding in one spot.
7. Finish with 1000 grit. This sets your final surface profile for smooth support marks without losing detail.
8. Texture check. At each grit, aim for one uniform scratch texture—no random deep lines mixed in.
9. Final cleanup. Vacuum/brush, then wipe with a clean cloth before the next stage.

Special Cases

If a deep scratch appears late, drop back one grit step and remove it before continuing.

Pro Tips

• Swap sheets when they stop cutting; clogged paper can leave random scratches.
• Reduce pressure as grits get finer.
• Wipe between grits so inspection is accurate.
• Use a block on flats to avoid finger grooves.

Aftercare

• Remove dust from seams and corners before coating.
• If wet sanded, dry fully before primer/paint/clear coat.
• Store unused sheets flat and dry.
• Discard heavily loaded sheets so old finish doesn’t re-scratch the surface.

FAQs

• Can I skip a grit? Skipping often leaves deeper scratches that show later. Use the sequence for predictable results.
• How do I know when to move up? When the scratch pattern is uniform and you can’t find lines from the previous grit under angled light.
• Why does the finish still look uneven? Usually because the first grit step wasn’t completed or debris re-scratched the surface.
• Why do I see haze or dullness? Often from uneven scratch texture. Keep strokes consistent and complete each grit step before moving up.

Watch & Learn

Here are the exact grits referenced in this workflow so you can match the sequence: 60 grit (pack of 25), 180 grit (pack of 25), 400 grit (pack of 50).

• 60 Grit Sandpaper Sheets — Pack of 25
• 180 Grit Sandpaper Sheets — Pack of 25
• 400 Grit Sandpaper Sheets — Pack of 50

Complete each grit step, inspect under angled light, and keep pressure light at the end. That’s the simplest route to a finish-ready surface.