Polished Concrete: Grit Sequence for Light Scratch Reduction

Intro

how to sand polished concrete for light scratch reduction goes faster when you treat sanding as a progression: level → refine → finish. The workflow below keeps the scratch pattern consistent on polished concrete and helps you reach light scratch reduction with fewer redo passes.

Why Sanding Matters

Sanding works because each grit removes the scratches left by the previous grit. If you skip too far, deeper lines remain and show after paint, stain, or clear coat. Steady grit steps are typically the quickest route to a clean, even-looking surface.

Recommended Tools

• Sanding block or hand pad
• Optional: interface pad for curves/delicate surfaces
• Vacuum/shop vac with brush attachment
• Microfiber or tack cloth
• Raking light (flashlight held low)
• Masking tape for edges

Recommended Grit Sequence

• 800 grit: Ultra-fine finishing between coats or polish prep.
• 1000 grit: Ultra-fine finishing between coats or polish prep.
• 1500 grit: Ultra-fine finishing between coats or polish prep.
• 2000 grit: Ultra-fine finishing between coats or polish prep.

Step-by-Step

1. Clean the surface first to prevent random deep scratches from debris.
2. Inspect under raking light and mark defects so you don’t over-sand the entire area.
3. Start with the first grit and sand until defects are leveled—then stop.
4. Vacuum and wipe before changing grits to keep scratch patterns clean.
5. Refine with a three-step progression: 800 Grit (50 Pack) → 1500 Grit (50 Pack) → 2000 Grit (50 Pack). Overlap strokes and keep pressure light.
6. Inspect after each grit. Move on only when the scratch pattern is uniform.
7. Final cleanup: vacuum, wipe, let dust settle, then wipe again.
8. Proceed to primer/paint/stain/clear coat.

Special Cases

Edges and corners: Reduce pressure and switch to finer grits earlier near edges to avoid sand-through.

Clogging (loading): Replace sheets as soon as cutting slows—loaded paper can burnish instead of cut.

Between coats: Use a very light touch to remove dust nibs; avoid aggressive leveling.

Wet or dry use: If wet sanding, use minimal water and wipe slurry often so it doesn’t dry into scratches.

Pro Tips

• Use light pressure and let the abrasive do the work.
• Vacuum between grits—coarse dust ruins fine finishing.
• Use raking light often; it reveals scratches you can’t see head-on.
• Keep the sanding pad flat to prevent grooves and waves.
• Match final grit to the coating and sheen you want.

Aftercare

• Remove all dust before coating for better adhesion and smoother finish.
• Prime or seal as recommended to prevent uneven absorption.
• Store sheets flat and dry.
• Label partially used sheets by grit.

FAQs

• Can I skip a grit? Big jumps often leave scratches that show later. Smaller steps reduce rework.
• How do I know when to move on? When the scratch pattern is uniform across the whole surface.
• Wet or dry sanding? Dry is common for prep; wet can reduce clogging on some materials.
• Does higher grit always mean better? No—choose final grit based on your finish system.
• Why do scratches show after coating? Usually the previous grit scratches weren’t fully removed.

Watch & Learn

Quick tip: For the cleanest finish, overlap strokes and keep your final pass direction consistent. If the finish still looks uneven, it’s usually scratch pattern + dust, not “not enough sanding.”

Need matching grits for your next project? Browse here: eQualle Sandpaper Collection.