How to Sand ABS interior trim to prep for adhesion promoter and

How to Sand ABS interior trim to prep for adhesion promoter and paint — use this grit progression to sand ABS interior trim for prep for adhesion promoter and paint with a consistent, predictable finish.

Why Sanding Matters

Sanding levels imperfections and creates uniform tooth so your next layer (primer, paint, stain, clear coat, or polish) goes on evenly.

Recommended Tools

• Sanding block or soft pad (keeps pressure even)
• Microfiber towels (wipe between grits)
• Tack cloth (final dust pickup)
• Spray bottle with clean water (wet sanding)
• Painter’s tape (mask edges/trim)
• Safety glasses and a dust mask

Recommended Grit Sequence

• 180 grit
• 220 grit
• 320 grit
• 400 grit
• 600 grit

Step-by-Step

1. Clean the surface and mask off areas you don’t want to sand.
2. Start with 180 grit to remove defects and level toward prep for adhesion promoter and paint.
3. Move to 220 grit and sand until the previous scratches are mostly replaced by finer marks.
4. Wipe clean and inspect under a bright, low-angle light; fix any deep marks before moving on.
5. Continue through 600 grit for final prep. Wet sand where it helps refine the scratch pattern and reduce dust.
6. Remove all residue, let dry, then proceed with your next finishing step.

Special Cases

Edges: Use lighter pressure to avoid sanding through.

Curves: Use a soft pad to follow contours without flattening.

Spot repairs: Feather outward with each grit to blend transitions.

Pro Tips

• Use overlapping passes and keep pressure consistent.
• Clean between grits so coarse particles don’t leave deep random scratches.
• If leveling is slow, step back one grit instead of pressing harder.
• For wet sanding, keep a thin water film and rinse the sheet often.
• Feather outward around repairs so the transition blends after finishing.

Aftercare

• Remove dust or slurry completely and wipe with a clean microfiber towel.
• Let the surface dry fully before applying primer, paint, stain, clear coat, or polish.
• Seal sanding dust in a bag for disposal.

FAQs

• Do I need to sand the whole area or just the defect? — Level the defect first, then blend outward so the repair disappears after finishing.
• How do I keep from leaving visible sanding marks? — Don’t move up until the scratch pattern is uniform, and avoid big grit jumps.
• What’s the easiest way to spot remaining deep scratches? — Wipe clean and use a bright, low-angle light. Deep scratches will stand out.

Watch & Learn

In the video, focus on when the surface is wiped clean and checked under light. That checkpoint is what prevents sanding marks from showing up later.

• View on Amazon
• View on Amazon
• View on Amazon

Use the Amazon links above to choose sheets that match your grit sequence and keep your sanding steps consistent.